How Do You Size a Full-Extension Ford Maverick Bed Drawer?

· 2 min read

Technical illustration of a pull-out bed drawer and slide runners

SIZE THE RUNNERS FROM THE TRUCK BEFORE CUTTING THE DRAWER

Last verified 8 November 2026

One Maverick owner used 48-inch full-extension slides, roughly 46½-inch drawer sides and a half-inch plywood base. Use the example to lay out your own truck before cutting wood. Check the actual width, slide gaps, cover height and tailgate access. Use vehicle-approved anchor points and plan how the loaded drawer will stay secured.

Fit Assistant · For your setup

Apply this to your Maverick

Use your truck and what you need from this decision.

What goes on the cut list?

PieceOwner’s starting pointWhat to measure on your truck
Two slide runnersTwo 2×6 pieces cut to the 48-inch slide lengthFlat length between the front wall and tailgate
Drawer sidesTwo pieces cut from 1×6 stock, about 46½ inches each in the owner’s designFit between the chosen front and rear panels
Drawer baseHalf-inch plywoodOutside drawer width after subtracting both runners and the slide maker’s side gaps
Rear runner tie and dividers1×4 rear tie cut to bed width, with removable plywood dividersBed-wall contour and the containers you actually carry

The owner reported $97 for the slide pair and $35 for a plywood sheet. Price your own lumber, latch, fasteners and mounting hardware before comparing the project with removable bins. Full extension is useful when you need to reach the cab end from the tailgate. Bins are easier to lift out when you switch from gear to bulky cargo.

Mock it up with the tailgate and cover closed

Start with cardboard for the drawer’s full outside width, length and height. Check the narrowest point and the path through the tailgate opening. Include any cover latches, drain hoses, liner lips and drawer pulls. Then check the space behind the open tailgate and whether your largest container can still lift out.

Choose a travel latch and an attachment scheme that can secure the drawer and contents independently of the slides. A published slide rating describes the slide in its specified installation. Compare this layout with Maverick drawers, slides and removable boxes.

Compatibility snapshot

SetupVerdictRequired check and source
Owner’s 48-in slide layoutA starting point for a drawingMeasure both sides of the actual bed and confirm slide gap and tailgate access before cutting. MaverickTruckClub full-extension drawer build
Drawer below a tonneau or other hardwareCheck the actual clear envelopeMeasure the underside of the cover and all fittings at the height of the loaded drawer. MaverickTruckClub full-extension drawer build
Drawer carrying cargo on the roadVerify the installation and load restraintsCheck the vehicle’s anchor and load guidance and the component maker’s instructions. Ford Maverick owner’s manual, load carrying

Sources & notes

Last verified 8 November 2026.